You can find high quality aftermarket elements exactly designed in your Civic on places like eBay for a fraction of the cost you’d pay for dealership parts. Aftermarket elements are an identical to the Honda manufactured parts, and if those break sooner or later, you will not feel so dangerous because you didn’t pay 3 times the quantity for it. One other approach to save some serious money on having to replace the mirror is to do it yourself. It’s not that arduous, and you most likely have the instruments lying around the house somewhere.
Honda Civic side mirror Replacement/Installation Instructions
1. Open the door and the window all the best way on the door of the side view mirror you could replace.
2. Flip the ignition key to off if in case you have power windows and mirrors, and take away the keys.
3. Locate the black plastic triangular molding on the interior door facet opposite the aspect view mirror. This is a snap-in piece of molding that may be pried away from the door with the screwdriver. You may must pry from completely different vantage factors until you can get your fingers underneath the molding and pull it away. Be careful to not scratch the paint on the interior side of the window frame. Inserting a rag or thick material underneath the screwdriver can be helpful.
4. Find the wire harness from the bigger center hole in the cavity of the door in case you have powered windows. The wire harness could have a bit little bit of play, and you will be able to control it to show the mirror plug and unplug it. You could have to make use of the screwdriver to press within the plastic locking tab of the plug. For manual mirrors, take away the mirror route deal with and inside sleeve.
5. Remove any foam or insulating plugs underneath the molding to expose the three studs and screws that hold the mirror to the door. Remove the nuts using the ratchet, extension and socket. Hold the telescopic magnet alongside every nut as you loosen it with the ratchet. It will help not dropping or dropping the nut down inside the door cavity.
6. Maintain the mirror on the outside whereas eradicating the last nut. This will probably be somewhat challenging, since you must hold a magnet while working a ratchet, and now add holding a mirror to the mix. Likelihood is, the climate stripping and the foam rubber padded safety beneath the broken mirror are going to hold it in place simply from being there and tight so long. However, you do not need the mirror to drop off and trigger a large and expensive scratch in your door panel whilst you’re attempting to carry out a repair to save money. Loosen the final nut and determine if the mirror is able to come off. If not, extract the nut with the magnet and work quickly. You will most certainly must persuade the mirror to interrupt its hold from the door.
7. Install the brand new mirror and punctiliously thread on the nuts. Tighten them with the ratchet, extension and socket, but be careful not to over-tighten and snap the mirror studs. For guide mirrors, you’ll have to additionally line up the mirror route handle. Remove the handle, set up the mirror, insert the sleeve on the inside of the door, then reinstall the handle.
8. Plug the wire harness again into the mirror plug and tuck the harness back inside the door cavity. It may be sensible to test the power to the mirror earlier than you close all the things up.
9. Substitute the black, triangular molding. It might have a lip that must be inserted into the window cavity. Make sure not to allow the lip to interfere with the operation of the window. Snap the molding into place.