2008 Honda Ridgeline Door Edge Guards Installation Procedures

1. Match up the door-edge protector items with the right doorways by matching up the contour of every protector with that of the door. Set each protector by every door to stop mixing them up.
2. Clean the sting of the door with a soap and water solution — solely use soap intended for cleaning automobiles — utilizing a clean, lint-free cloth and a bucket.
3. Rinse the door off with clear water and allow it to dry.
4. Apply a thin coat of paste wax — this course of varies depending on the kind of wax used, so discuss with the wax’s instructions.
5. Set the edge guard on the door edge loosely, so its contour lines up completely with the contour of the door. Draw a small line on the within of the door at the high and bottom of the sting guard with a everlasting marker. Remove the edge guard.
6. Lower the seam sealant — the physique-coloured silicone sealant sealing the joint between the door pores and skin and door frame — off the door edge between the 2 marks made in Step 5, using the seam cutter included with the edge guard kit. This gives a easy floor for the edge guard to set on.
7. Paint any areas where the paint peeled off whereas removing the sealant, using touch-up paint. Paint over the traces you made with the permanent marker, utilizing the touch-up paint. Allow the touch up paint to dry and cure, in line with the paint’s instructions.
8. Set the edge guard on the door edge with the curled end on the outside of the door. Tap the edge guard onto the door edge with a rubber mallet. Shut the door.
9. Repeat Steps 2 by way of eight to mount the remaining three doors.